Kenwood MIDI M-97 Instruction Manual page 52

Recording of CD playback (CCRS) (M-97M)
ra eR Ane aN pee a I FT I a I NEE Ts EE
DOLBY NR key MODE key
@ FADE recording CCRS keys
This function allows to provide fade-out and fade-in DIRECTION key
at the location where the tape is reversed.
: To record by track No. sequence:
1 Set up Deck B ready for recording.
a '4
_
P.MODE Cc
@ Set the tape o1se No.
transport direction.
a CI
emote control unit
@ Select the tape side(s) indicator goes off.
to be recorded.
DIRECTION
=) = Two-xide tecoraing 5 Select the FADE recording mode.
=" = : One-side recording
@ Select the Dolby NR mode.
DOLaY NA
[B FADE
[FADE |—» ERASE —» CROSS
2 Select the CD/LD input. ee ee
The mode changes every time the key is pressed.
3 Insert the disc in the CD player.
@ Close the door. 6 Press the |CCRS| key.
4 Select the disc and track to be recorded. Normal-speed recording. Double-speed recording.
NOR CCAS HIGH NOR CCRS niGH
To record by programmed sequence: Cj
@ Enter the|PGM| mode. @ Program desired tracks
P.MODE in desired order.
@ Refer to page 32.
e or is displayed in the display.
Recording occurs as shown below.
Remote control unit oo ee Fade-out in the middle of C
Fade-out <=" Fade-in in the middle of C
Notes:
1. When the key is pressed during CD play, the playback is interrupted and CCRS setting operation starts.
2. The CCRS searches the peak level on a CD in a limited period of about 60 seconds. Therefore, it could happen that the optimum level can-
not be adjusted, through it is a very rare case.
3. If the length of a track on the CD is extremely long such as with a classical music, the CCRS cannot be used because the music cannot be
fit inone side of tape. In such a case, the CD should be recordec referring to "Synchro recording of CD playback".
4. When the remaining length of a tape is short, the erase recording may be carried out at the end of the tape.
5. When a music piece at the end of the tape is to fade out, if the space between this piece and the previous piece is smail, a portion of the
end of the previous pieces may also be erased.
52 m-97/97M(En)