Table of Contents
Advertisement
M-97M(DP-M87)
@ Normal EDIT recording
This function allows to be edited, according to the record-
ing time of the tape, to ensure the order of the CD tracks so
that no track is interrupted at the end of each side of tape.
1 Set up Deck B ready for recording.
@ Insert the cassette tape.
6
Input the two-way recording time of the tape.
Tape to be recorded
Use the numeric keys of the remote control unit.
C-60 tape: Press [+10] 6 times, and[0| once.
C-46 tape: Press |+10] 4 times, and/6] once.
@ Set the tape
bs
7
@
46,
54,
60
or
90
can
also be
selected
every
time
the
transport direction.
[TIME |key is pressed.
In this case,
press the [EDIT MODE
key again to establish the input.
@
Tracks are edited automatically to fit sides A and B, and the end
of editing is indicated when
the EDIT indicator changes from
blinking to continuous lighting.
@ Select the tape side(s) to
be recorded.
DIRECTION
Select the mode with the IMODE|key of the
cassette deck.
> : Select two-side recording.
MODE
thy a FADE —»
ERASE —»
aa
@
Normal edit recording takes place
when you select[FADE]or[ERASE].
@ When you select[CROSS], the intervals between music pieces
are linked by overlapping of fade out and fade in so that edit
recording with no breaks between
pieces takes place. In the
CROSS mode, the double-speed recording is not possible.
@ Select the Dolby NR
mode.
DOLBY NA
goes off.
2 Select the CD/LD input.
3 insert the disc in the CD player.
@ Close the door.
@ Verify that the ;PGM indicator is extinguished. lf even only one
tune is programmed, editing cannot be carried out.
8 Press the
key.
NoR_CCAS Hick
Normal-speed recording
Thy
Double-speed recording
Nor CORE HiGH
@
in the|CROSSjmode, the double-speed
Ch
recording is not possible.
4
Select the EDIT mode with the
EDIT MODE|
key of the CD player.
EDIT|~=——»
Al EDIT
The mode changes every time
the key is pressed.
@ | HIGH] or [NOR. |is displayed in the
display.
@
Proceed to the next step within 8 seconds after setting |EDIT]
Recording occurs as shown
below .
If 8 seconds have elapsed, press the|EDIT MODE|key again.
Track subjected to
@ The CD playback mode is set automatically to|PGM |
time adjustment
@ When using the
[SPACE}key, press the
EDIT MODE
pressing the [SPACE]key in [PGM }.
key after
5
Press the disc selector key to select the
disc to be recorded.
ml
DISC NO.
Tracks are recorded basically according to their numbers, but some
tracks are replaced with tracks subjected to time adjustment.
Remote contlol unit
@ The CD player and cassette deck enter the stop mode automati-
cally after the completion of recording.
Note:
When the time entered on CD player is longer than the recording tape, the music piece at the tape end fades out if FADE
|has been select-
ed with the
|MODE]
key on the cassette deck. It ERASE}
has been selected. Confirm that the input time and the tape time are matched ac-
curately.
M-97/97M(En)
55
Advertisement
Table of Contents
