Pole Mounting The Ap Using The Cisco Kit - Cisco Catalyst Wireless 9163E Manual

Pole Mounting the AP using the Cisco Kit

Pole Mounting the AP using the Cisco Kit

The AIR-MNT-VERT1= mounting kit contains a mounting bracket used for both wall mounting and pole
mounting. This kit can be used to install the AP on a pole or mast. It supports metal, wood, or fiberglass poles
of 2 to 3.9 inch (51 to 99.06 mm) in diameter.
Figure 11: AP Mounted on a Pole
1
2
3
4
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a pole:
Table 8: Materials Needed to Mount the AP on a Vertical Pole using AIR-MNT-VERT1= Kit
Materials Required
One wall mount bracket
Four M6 x12 mm hex head bolts
Two stainless steel band clamps (adjustable 2 to 3.9 inch (51 to 99.06
mm)
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
26
One of four M6 keyhole slots for mounting the AP on the bracket.
Top and bottom sets of band clamp slots for passing the clamps through.
Top and bottom steel band clamps
Pole (wood, metal, or fiberglass), 2 to 3.9 inch (51 to 99.06 mm) diameter
Installing the Access Point
Supplied in the Kit?
Optional Cisco orderable accessory
Yes
Yes