Network Deployment
Configuring Wireless Controller
Configuring 6-GHz Radio Profile
This procedure enables the 6-GHz radio DCA channels in the controller.
Note
Procedure
Step 1
Log in to the Catalyst 9800 controller.
Step 2
Choose Configuration > Tags & Profiles > RF/Radio.
The RF/Radio page is displayed.
Step 3
In the RF tab, click default-rf-profile-6ghz.
The Edit RF Profile window is displayed.
Step 4
Click RRM > DCA tab.
Step 5
Ensure all the DCA Channels are enabled.
Step 6
Click Update & Apply to Device.
Configuring 6-GHz OFDMA
This procedure enables the 6-GHz radio OFDMA in the controller.
Procedure
Step 1
Log in to the Catalyst 9800 controller.
Step 2
Choose Configuration > Radio Configurations > High Throughput > 5 GHz Band > 11ax.
Step 3
Check Enable 11ax check box.
Step 4
Check the check boxes for the desired MCS/(data rate), or to select all of them, check the Select All check
box.
Step 5
Choose Configuration > Radio Configurations > High Throughput > 6 GHz Band.
Step 6
Check the check boxes for the desired MCS/(data rate), or to select all of them, check the Select All check
box.
Step 7
Click Update & Apply to Device.
The CW9163E AP's 6-GHz radio is enabled for use in AFC approved countries only.
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
Configuring Wireless Controller
45