Cisco Catalyst Wireless 9163E Manual page 40

Installing a CAT 5e Ethernet Cable and Gland Assembly to the Access Point
Note
Step 8
Slide the terminated RJ45 connector into the clamp ring till it stops.
Pull the cable to ensure that the connector is seated into the clamp ring.
Step 9 Rotate the Cable Seal Nut to tighten the seal around the cable jacket.
Use an adjustable or 18 mm wrench and torque to 7-9 lbf-in (8-10 kgf-cm).
Step 10 Insert the RJ45 cable gland assembly into the port on the AP.
Thread the screw nut onto the AP threaded port and tighten by hand to be sure the gland seals to the port.
Torque to 15 lbf-in (17 kgf-cm), if possible.
Step 11 Route your Ethernet cable and cut off any excess cable.
Step 12
Install an RJ45 connector on the unterminated cable end and insert it into the power injector or device PoE
port.
Step 13 Turn on the power to the power injector.
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
32
Ensure that the RJ45 connector end where the cable enters is free from cable foil, shielding, or
jacket that was peeled back during termination. If any material is left, this may cause internal
component interference and fail to seal properly to the RJ45 port.
1 RJ45 connector end where the cable enters, terminate the cable foil,
shielding, or jacket that was peeled back during termination at this line.
Installing the Access Point