Table of Contents
Advertisement
Attaching an F-type Connector (not supplied)
1 Strip 17 mm (11/16") of the black polyvinyl jacket.
2 Fold back the woven wire.
3 Strip 12 mm (1/2") of the white plastic casing,
leaving 12 mm of the center conductor.
4 Slip the crimping ring over the cable.
5 Insert the inner conductor into the F-type
connector shaft and push the end of the cable into
the connector as far as it will go.
6 Slide the crimping ring over this assembly.
Pinch the crimping ring with pliers to hold the
connection in place.
Estes
General Setup Information
81
Advertisement
Table of Contents
