Table of Contents
Advertisement
Setting the Time and Date
You can set the time and date between years 1992 and 2007.
After setting the year, month, date and time, transmit them to the VCR.
Before you begin
¢
Use the + side of the clock set buttons to increase the digit.
*
Use the — side of the clock set buttons to decrease the digit.
«
You do not have to set the day of the week.
The day of the week is automatically set after the date is set.
Example of Time and Date Setting
Example: To set to 9:30 am, July 4, 1992
1 Open the cover of the Remote Commander.
2 Press CLOCK SET.
3 Press D (DAY) until "M7 Y92" appears.
The day is advanced slowly up to 30 (31)
as
~
days ahead and then the month is
3 by,
Kk
c: ae
advanced.
When the number of your desired month
appears, release your finger from the
button.
4 Press D (DAY) until "4D" appears.
The day of the week is set automatically.
window of the VCR
If the power is interrupted for more
than one hour, "— : — —" lights up in the
display when the power is restored.
You will have to reset the date and
sack abel
5 Press the H (hour) and M (minute) buttons
If a short beep sounds repeatedly
under the TURN OFF section to set
The VCR is in timer recording or
9:30 A.M.
quick-timer recording mode and the
setting cannot be transmitted.
If the batteries are replaced
6 Point the Remote Commander at the VCR
and press TRANS.
A beep sound confirms that the date and clock setting has been correctly
transmitted to the VCR and stored in the VCR as well.
The clock on the VCR will start counting.
Reset the clock correctly.
If the clock on the Remote
Commander is correct but the
VCR's clock is incorrect
@ Open the cover of the
Remote Commander and press
CLOCK SET.
@ Point the Remote Commander to
the VCR and press TRANS.
The present time is correctly
transmitted in hours, minutes and
seconds.
7 Check the display window on the VCR and close the cover.
24
Setting the Time and Date
Advertisement
Table of Contents
