Microphone Control - Kenwood TH-235A Instruction Manual

MICROPHONE CONTROL
After connecting the optional SMC-33 or SMC-34 speaker
microphone, you can change numerous transceiver
settings without using the transceiver keys or controls. The
1, 2, and 3 keys located on the top of the microphone are
programmable with the transceiver key (or key
combination) function. The assigned default functions are
as follows:
[1]: [VFO] (VFO Select)
[2] : [MR] (Memory Recall)
[3] : [C] (Transmit Power Select)
1 Press one of the following key combinations depending
on which key you want to re-program:
Mic [1]+ POWER ON ("PF 1" appears)
Mic [2]+ POWER ON ("PF 2" appears)
Mic [3]+ POWER ON ("PF 3" appears)
2 Press a key or key combination on the transceiver that
you want to assign.
e Youcan press the following keys.
[MONI]: Monitor ON/OFF [VFO]: VFO Select
e You can also press the following key combinations:
[F], [MONI]: Squelch Adjust
[F], [VFO]: Memory ~ VFO
[F], [MR]: Memory Channel Store'
[F], [A]: RX/TX Tone Frequency Select
(F], (B]: Transceiver Lock ON/OFF
[F], [D}: Lamp Latch ON/OFF
(F], [#]: Offset Direction Select
[F], [1]: DTSS ON/OFF
[F], [2]: DTMF Number Confirm
[F], [3]: CTCSS ON/OFF
[F], [4}: DTSS Code Store
[F], [5]: DTMF Number Store
[Fl, [6]: RX Tone Frequency Select
[F], [7]: Frequency Step Size Select
[F], [9]: Memory Channel Lockout ON/OFF
[F], [0]: Offset Frequency Select
'Available in place of transceiver [MR] when storing data
in memory channels {page 17}.
Note:
[MR]: Memory Recall [A]: Tone ON/OFF
[B]: 1 MHz function ON/OFF = [C]: TX Power Select .
[D]: Lamp [*]: Menu +
[#]: Reverse ON/OFF <
e
To assign the Up function, rotate the Tuning control
e
clockwise. To assign the Down function, rotate the Tuning
control counterclockwise. o
Tum OFF the transceiver power before connecting an option.
If the LOCK switch located on the rear of the microphone is ON, you
cannot re-program the Programmable Function keys.
Pressing the PTT switch in step 2 assigns the VFO/MR switch.
Pressing [0] to [9] in step 2 allows you to recall a memory channel
number 0 to 9.
Pressing the PTT switch, [C], [+], or [8] after pressing [F] will assign
no function.