Table of Contents
Advertisement
Remote control unit
@ Batteries are exhausted.
@ The audio cords and the system
control
cords are not connected properly.
@ The remote
control unit is too far away
from the main system, controlling angle is
too
large,
or there
is an
obstacle
in
between.
@ The
source
component
to be operated
does not contain the analog disk, tape(s)
or CD.
@ An attempt is made to play a tape which
is being recorded in the cassette deck.
Remote control operation is not possible.
Amplifier, speakers
@ The
VOLUME
is set
to the
minimum
position.
@ The MUTING key of the amplifier is set to
ON and the point indicator is blinking.
No sound comes out, and "PROTECT"
is
shown on the display.
@ Speaker cords are short-circuited.
speakers.
@ The
BALANCE
control
extreme position.
is
set
to
an
or the sound is very low.
@ The Dolby 3 Stereo mode has been se-
lected.
@ REAR VOL. has been reduced to the low-
est level possible.
@ MASTER
VOLUME
has been reduced to
the lowest level possible.
@ The rear speaker switch is at OFF.
speaker, or the sound is very low.
@ Dolby
Pro Logic, 3 Stereo
or Presence
mode has not been selected.
@ PRESENCE VOL. has been reduced to the
lowest level possible.
@ CENTER VOL. has been reduced to the
lowest level possible.
@ MASTER VOLUME
has been reduced to
the lowest level possible.
@ The center speaker switch is at OFF.
@ The audio cord from the turntable is not
inserted securely into the PHONO jacks.
@ The turntable is not grounded.
A hum noise is generated when the
PHONO input selector key is pressed.
54 .85/M-959 (En)
@ Replace with new batteries.
@ Connect
properly
referring to provided
Connecting diagram.
@ Operate the remote control unit within
the controllable range.
@ Place an analog disk, tape(s) or CD in the
source component to be played.
@ Wait until the recording is completed.
@ Connect
properly
referring
to
provided
Connecting diagram.
@ Adjust the volume to a proper level.
@ Press the MUTING key to OFF.
@ Unplug the power
cord, eliminate the
short-circuiting, then turn on the power
again.
@ Connect
properly
referring to provided
Connecting diagram.
@ Adjust the Left/Right balance.
@ Connect
properly
referring
to provided
Connecting diagram.
@ Select Dolby Pro Logic or the Presence
mode.
@ Adjust REAR VOL.
@ Adjust MASTER VOLUME.
@ Set the rear speaker switch to ON.
@ Connect
properly
referring
to
provided
Connecting diagram.
@ Select Dolby Pro Logic, 3 Stereo or the
Presence mode.
@ Adjust PRESENCE VOL.
@ Adjust CENTER VOL.
@ Adjust MASTER VOLUME.
@ Set the center speaker switch to ON.
@ Insert the audio cord plugs securely into
the PHONO jacks.
@ Connect the grounding wire to the GND
terminal on the rear panel.
Advertisement
Table of Contents
