Tape Dubbing - Kenwood MIDl M-85 Instruction Manual

Tape dubbing
1 Insert tapes in the cassette decks.
DUBBING keys
Initial tape
transport
directions
To stop dubbing
Press the B deck stop key.
REC LEVEL +6
To pause dubbing
ct one-way or two-way dubbing mode.
3 Sele id
y
9
Normal-speed dubbing : Press the NOR. key.
High-speed dubbing __: Press the HIGH key.
DIRECTION
] For two-way dubbing
@ Only deck B enters the record-pause mode after leaving a
non-recorded space of about 4 seconds in case of normal-
speed dubbing, or about 6 seconds in case of high-speed
dubbing.
@ To skip tunes you do not want to dub on another tape dur-
ing dubbing, press the[ mm] key of Deck A.
@ To resume dubbing after pause, press the same DUBBING
key as above ([NOR] or ) again.
o
( 4
| t
= For one-way dubbing
The mode changes every
time the key is pressed.
4 Press the A.BIAS key.
B start dubbing.
DUBBING Siaanne
iol mick NOR HIGH
1. The recording level cannot be adjusted for dubbing.
2. The DOLBY NR key does not function during dubbing.
The tape recorded by dubbing features the same NR system
as the original tape in Deck A.
3. Noise from TV may interfere with dubbed sound if high-speed
dubbing is executed near a TV set. To prevent this, install the
i. _ We system farther from the TV set.
wa at aa a Se quality may be degraded if high-speed dubbing is used. In
such a case, use normal-speed dubbing.
36 v-85/1-959 (En)