Table of Contents
Advertisement
1. Move the actuator to the closed position.
2. Place O-rings 1 and 2 into threaded adapter 3.
3. Screw threaded adapter 3 into the actuator opening as far
as it will go and tighten.
11.4 Preparations for assembly to the valve (quarter
turn actuator)
1. Move the actuator A into zero position (actuator vented).
A
2. Remove the screw 1 from the trigger cam 2.
www.gemu-group.com
11.5 Rotary travel sensor mounting kit assembly
1
3
2
Determining the rotational direction of the actuator
▶ When viewed from above, the rotational direction of the
1
2
1. The shaft of the rotary travel sensor is provided with a
2. Set the marking 2 so that it is correctly aligned with the 0°
3. Place the adapter 4 onto the shaft of the rotary travel
19 / 76
NOTICE
actuator must be anticlockwise, when the actuator moves
from the CLOSED to the OPEN position. In cases where
the actuator turns in a clockwise direction, the travel
sensor's end position, contrary to given instructions,
needs to be in the opposite direction.
2
OPEN
ERROR
marking 2.
CLOSED
POWER
2
position on the underside of the travel sensor housing.
The 0° position is located on the left-hand side of the
cable exit (the electrical operating range is located in the
travel range between the 0° and 90° positions).
2
4
sensor 2 without twisting the shaft.
11 Assembly
eco
GEMÜ 1436 cPos
Advertisement
Table of Contents
