Table of Contents
Advertisement
Introduction
On safety
Operate the printer on 120 V AC, 60 Hz only.
Be careful not to set or drop any heavy objects on the power cord, or to damage the cord in any
way. Never operate this printer with a damaged power cord.
Should any solid object or liquid fall into the cabinet, unplug the printer and have it checked by
qualified personnel before operating it any further.
Never disassemble the printer.
To disconnect the cord, pull it out by the plug. Never pull the cord itself.
When the printer is not going to be used for an extended period, disconnect the power cord from
the wall outlet.
Do not handie the printer roughly.
¢ To reduce the risk of electric shock, always unplug the printer from electrical outlet before
cleaning and servicing the printer.
| On moisture
i
e
If the printer is brought directly from a cold location to warm place or placed in an extremely warm or
|
condensation
humid room, moisture may condense inside the unit. In such cases the printer will probably not work
:
properly and may even develop a fault if you persist in using it. If moisture condensation forms, turn
|
off the power and do not use the printer for at least one hour.
_
Oncleaning
Clean the cabinet, panel and controls with a soft dry cloth, or a soft cloth lightly moistened with a
mild detergent solution. Do not use any type of solvent, such as alcohol or benzine, which may
damage the finish.
On installation
Avoid placing the unit in a location subject to:
—vibration
—high humidity
—excessive dust
—direct sunlight
—extremely high or low temperatures
Do not use electronic equipment near the unit. The unit will not work properly in electromagnetic
fields.
The unit is designed to operate horizontally. Never attempt to operate the printer in a tilted
position.
If the unit was placed on its side or with its top panel facing down, make sure to remove the paper
tray and check that print paper is placed properly before starting operation.
e Do not place heavy objects on the printer.
Leave enough room around the printer so that the ventilation holes are not blocked.
Blocking these holes may cause internal heat build-up.
Ventilation holes
Advertisement
Table of Contents
