Table of Contents
Advertisement
Setting Up
Load the video print paper
according to the following
procedures. Use only the video
print paper and the video print
Cartridge packed in the same
carton.
Note on handling the video
print paper
Do not touch the printing surface
(the side where nothing is
printed). Do not place the print
paper in a dusty location.
Fingerprints or dust on the
printing surface may result in
impertect printing. Use the print
paper recommended for this
printer only. If you use a different
type of paper, the printer may not
print properly or may cause
problems.
14
@ Open the printout
cover, @) open the
paper compartment
lid and @ remove
the paper tray.
Printout cover
How to reattach the printout
cover
If you open the printout cover
forcibly or put force on the
hinges, the printout cover may
come off from the unit. In this
case, fit the two hinges onto
the pins from directly above to
reattach the cover.
(If it is NOT done from directly
above or too much force is put
on the hinges, the hinges or
the pins may be damaged.)
2 Insert the video print paper in the paper tray.
Determine which side is the
printing surface.
For regular and sticker print
paper, the printing surface is
the shiny side where nothing
is printed.
Printing surface
(sticker print
paper)
2 Ruffle the print paper.
mm
3 Make sure that the tray
spacer is lifted.
If you insert the regular print
paper or the sticker print
paper in the paper tray while
the spacer is down and
continue operations, paper
jams may occur.
For regular and sticker print
paper. keep the spacer raised
4 Check that the corners of
the print paper are not bent.
and then place the paper in
the paper tray with the
printing surface facing up.
Printing
surface
Make sure that the
Pnni paper is
placed below the
paper holder
Advertisement
Table of Contents
