Table of Contents
Advertisement
Confirming and error beeps
When you press a button on
the main unit or remote
commander, a beep sounds to
show that you have done an
expected step of the operation.
If you have done an
unacceptable step, repeated
beeps sound to show that the
printer rejected your operation.
Repeat the operation carefully,
referring to the steps shown in
this manual.
if the stored image is blurred, press
the FIELD/FRAME button to select
the FIELD A or FIELD B mode. (If
the stored image is not blurred,
proceed to step 4.)
To change the image stored
in memory
Press the SOURCE button.
Each time you press the FIELD/FRAME button,
the indication on the screen changes in the order
of FRAME — FIELD A > FIELD B > FRAME.
Select the FRAME/FIELD mode, checking which
mode eliminates the blur most.
Image in FRAME mode
(blurred)
g > S
The stored image disappears
and the playback picture
returns to the screen. When
the image you want to print
appears, press the CAPTURE
button again to store a new
image. The previous image in
memory is replaced with the
new one.
What blurs the stored image ?
The stored image is blurred because the motion
of the image is so fast that the image changes
while the printer is storing the image in the
FRAME mode. If you print this image, the picture
on the printout will also be blurred. To eliminate
the blur, press the FIELD/FRAME button to
select the FIELD A or FIELD B mode, checking
which mode eliminates the blur more. The
picture quality, however, may become coarse
when printed in the FIELD mode. When the
Stored image is not blurred, we recommend you
to print in the FRAME mode. For details, refer to
"FRAME mode and FIELD mode (About Memory
(Capture) Mode)" on page 45.
17
(to be continued)
Advertisement
Table of Contents
