Vehicle Cleaning And Storage - KEEWAY RK V125 C User Manual

XIV. Vehicle cleaning and storage
1. The motorcycle should be cleaned regularly in order to discover the damage, wear or oil leakage of the vehicle in time.
2. When cleaning, you must wait for the engine to cool down and rinse with clean water. After cleaning, dry the motorcycle and start the engine and
let it run for a few minutes; lubricate the chain with lubricating oil; check the brakes before driving on the road, and the front and rear brakes should
be normal.
3. Parts that cannot be sprayed with high-pressure water: headlights, turn signals, ignition switch locks, electrical switches, meters, electrical parts
and wiring, batteries, air filters, hubs, exhaust pipe outlets, under the fuel tank and engine Cylinder head, etc. These parts are best wiped with a rag.
EN
4. After cleaning, the braking performance may be reduced, so you must try to ride it and check it before it can be used after adjustment and
recovery.
[Vehicle storage]
After the motorcycle is used on the day, it should be stored in a dry, safe place with small temperature differences and good ventilation. If it is
stored for a long time (more than 30 days), necessary repairs should be performed before storing the motorcycle; otherwise, the problem that
needs repairs may be forgotten when the motorcycle is used after storage. Long-term storage (more than 30 days) should be maintained in
accordance with the following requirements in addition to the above maintenance:
1. Clean and dry the motorcycle, and wax the painted surface of the whole vehicle.
2. Drain the fuel out of the fuel tank and spray anti-rust agent into the fuel tank.
3. Thoroughly drain the oil and refill the crankcase with new oil.
4. Remove the spark plug and inject a small amount (15-20 ml) of lubricating oil into the cylinder; then reinstall the spark plug, turn on the ignition
switch lock, and press the start button for 2 to 3 seconds to distribute the oil evenly on the cylinder wall.
5. Remove the battery, remove the rust on the terminals and wiring connectors, and store it in a well-ventilated, dry, cool place and avoid direct
sunlight.
6. Inflate the tire to the specified air pressure and place the motorcycle above the cushion block to keep the front and rear wheels off the ground. If
the tire pressure is too low, the tire will age prematurely and cause cracks.
7. Cover the air inlet of the air cleaner and the exhaust outlet of the exhaust muffler with a rag containing new engine oil to prevent moisture from
entering.
8. Cover the motorcycle with a material with strong air permeability and store it in a dry, safe place with small temperature difference and good
ventilation.
60