Operation Guidance; Running In - KEEWAY RK V125 C User Manual

V. Operation guidance
5.1. New vehicle running-in
The running-in period refers to a treatment method that is carried out in order to ensure that the joint surface between the parts and the parts
becomes the best joint state during the initial use of the new vehicle. The correct running-in operation can maximize the life of the vehicle.
New vehicle running-in mileage: 1500km.
EN
1. During the running-in period, it must be done: the throttle should be avoided to operate fully, and the maximum engine speed should not
exceed 6500 rpm (see the instrument). The vehicle speed is controlled in the following range:
0～300km running-in:
Avoid opening the throttle handle to exceed 1/2 of the maximum opening; the vehicle speed is within 50km/h.
300～600km running-in:
Avoid opening the throttle handle to exceed 2/3 of the maximum opening; the vehicle speed is within 60km/h.
600～1500km running-in:
The throttle handle should not exceed 3/4 of the maximum opening; the vehicle speed should be within 70km/h.
2. Avoid continuous low speed: When the engine is running at a certain low speed (light load), the parts will be polished smoothly and the
running-in will not be good.
3. Reasonable use of each gear: Don't continue driving at a fixed engine speed. You can change the speed appropriately so that all parts of the
engine can "carry" the pressure, so that the engine can run in better.
4. Before driving, let the engine oil circulate: after the hot and cold engine is started, and before the load is applied, the engine must be allowed to
idle for sufficient time, so that the engine oil can be lubricated to all important parts of the engine, reducing wear and extending use Life, it can also
warm up the engine well.
5. Running-in of new tires: The tires also need to be run-in. Before the new tires are run-in, you should gradually increase your turning angle within
160 kilometers, but avoid sudden braking, rapid acceleration and sharp turns.
23