Page 1
No claims will be asserted as a result of such discrepancies. Dimensions, weights, fuel consumption and performance data are quoted to the customary tolerances. The right to modify designs, equipment and accessories is reserved. Errors and omissions 125-2G/150-2G/200-2G excepted. 2015FEB02...
! WARNING INTRODUCTION INTRODUCTION ● Engine break-in Safety information ● Parking Please read this manual carefully and completely ● Safe-riding PERIODIC MAINTENANCE AND Welcome to the world of motorcycling! before operating this vehicle. ● Further safe-riding points ADJUSTMENT As the owner, you are benefiting from the vast experi- DESCRIPTION ●...
● This vehicle is designed to carry the operator and thoroughly familiar with the vehicle and all of its con- the result of head injuries. The use of a safety helmet SAFETY INFORMATION is the most critical factor in the prevention or reduc- a passenger.
DESCRIPTION Left view or smell any engine exhaust. Deadly levels of carbon ● Railroad crossings, streetcar rails, iron plates on monoxide can collect rapidly and you can quickly be road construction sites,and manhole covers become overcome and unable to save yourself. Also, deadly extremely slippery when wet.
CONSUMER INFORMATION INSTRUMENT AND CONTROL Meter & Indicator FUNCTIONS ● The vehicle identifi- cation number ① is “ ” (Off) position: 5 6 7 stamped on the right All the circuits are off. side steering head tube. “ ” (On) position: ●...
HANDLEBAR Dimmer switch Front brake lever Engine stop switch (IF EQUIPPED) LEFT HANDLE Pull the brake lever properly to use the front brake. When the switch is on " " position and the power Turn the switch to " " position, the high beam of is on, the engine runs.
REAR BRAKE PEDAL (Reserve) position ! ditions. Adjust when vehicle it is stable on the main WARNING When the fuel switch is on " " (Reserve) position, stand or side stand, turn the preload ring to the place Step the rear brake pedal to brake the rear wheel. Do not over fill the fuel tank.
PRE-OPERATION CHECKS OPERATION AND IMPORTANT ITEM CHECKS ITEM CHECKS RIDING POINTS Disc brake • Check operation. Wheels and tires • Check for damage. Inspect your vehicle each time you use it to make ( If equipped ) • If soft or spongy, have dealer bleed •...
ACCELERATION AND DECELERATION vehicle owner/operator. The most important points of range. It is strongly suggested to use the vehicle WARNING ! The speed can be adjusted by opening and closing vehicle inspection, adjustment, and lubrication are very carefully during its running in period; also the It is dangerous only to use either the front brake the throttle.
CHECKING THE SPARK PLUG 2. Start the engine, warm it up for several minutes, NOTICE The spark plug is an important engine component, and then turn it off. which should be checked periodically, preferably by 3. Wait a few minutes until the oil settles, remove The engine oil should be between the minimum a dealer.
IDLE SPEED AIR FILTER CHECKING THE THROTTLE CABLE CHECKING THE FRONT BRAKE LEVER AND FREE PLAY REAR BRAKE PEDAL FREE PLAY Good carburetion is the key of engine performance. The air filter element should be replaced and should Keep the original condition of the carburetor, as set be cleaned at the intervals specified in the periodic The throttle cable free play should measure 3.0–5.0 The brake lever free play should measure 10-20 mm...
CHECK THE DRUM LIMIT BRAKE FLUID (IF EQUIPPED) CHECKING THE BATTERY Check if braking function is normal, and if the limit index extension line is within the allowable Adjustment Nut Brake system is tuned before delivery. Contact range, as shown in Figure A. dealer if any problem.
dard range. Adjust the tire pressure under a "cold" 2. Lubricate drive chain. REPLACING THE FUSES AND BULBS condition. 3. Drain fuel in fuel tank and carburetor out. Meter Light 12V 2W Install the fuel tank cover again. If a fuse or bulb for the individual circuits is blown, Horn 12V 3A 4.