Panasonic DVD-RV80 Operating Instructions Manual page 41

DVD
Altematlve soundtrask (or
subtitle) languages fail to be
selected.
Soundtrack and/or subtitle
language is not the one selected
at the initial settings.
French (example),
Sound does not come from a
speaker.
The vocals cannot be turned off.
An alternative language is not selected with discs which do not contain more than one language.
In the case of some discs, the alternative language cannot be selected by operating the [AUDIO] or
[SUBTITLE]. Try selecting it from the disc's menu if one is available. •
_flJncti0" iSdepende_ _ _Harea_iabilPq/I E_" if: _ diac has a,d_ber 0f ang!_ _ Ort;l_,
_:angle s may be _rded for_ scenes only (whe n =ANGLE" lights UP _n the p_er's FL
display). :
If the scundtreck and/or subtitle language does not exist on the disc, the language selected at the
initial settings will not be seen/heard.
The setup =3 Menus'of ,! Disc Languages" IS setto French: Select English: O
Check the connections. O O 0-0
If you have connected this player to an amplifier through the audio output terminals, go to the initial
settings menu =8 Speaker Setting" and change the settings to suit your speakers. Select "Yes" for all
the speakers you have connected. O
DVD-RV60 cannot decode DTS encoded discs. To enjoy DTS encoded discs, connect to an
amplifier that has a DTS Digital Surround decoder. •
if you have connected this player to an amplifier (with built-in decoder) through the digital audio
output terminal, go to the initial settings menu "7 Digital Audio Output" and change the settings to
=Bitstream" for "2 Dolby Digital" or "3 DTS Digital Surround". •
Sound will only come from the two front speakers if V.S.S. is on. Turn V.S.S. off. •
CLOSE] on _ plaYer until'lh_dh_pp _ frame.on (after about 3_): :
:AI! initial settings _ _m m _ _s_
You have setected an audio channel that includes a vocal channel. Read the disc's jacket to choose
the correct channel. •
Video CD
I No menu play. I This functionworksonlyfor Video CDs with playbackcontrol.•
When an error or trouble is detected during operation, a message appears in the FL display.
When a message has appeared, check the details given below.
Message Player status Remedy
CHECK THE DISC Disc is dirty. Wipe the disc dean.
H[Z][_ Trouble is likely to have occurred. The Press [POWER _/I] to switch the player to the standby mode and
number following "H" differs depending on then back to ON. Alternatively, press [POWER _O/I] to switch the
r-]l_ stands the status of the player, player to the standby mode, disconnect the AC power supply cord,
for a number, and then reconnect it.
elf the message fails to be cleared, even when remedial action is taken, ask a service technician to repair the player.
II
#=
VQT8621