Port Security; Port Limit Control - Planet Networking & Communication GS-6320 Series User Manual

• Last Supplicant/Client
Info

4.6.4 Port Security

4.6.4.1 Port Limit Control

This page allows you to configure the Port Security global and per-port settings.
Port Security allows for limiting the number of users on a given port. A user is identified by a MAC address and VLAN ID. If Port
Security is enabled on a port, the limit specifies the maximum number of users on the port. If this number is exceeded, an action
is taken depending on violation mode. The violation mode can be one of the four different described below.
The Port Security configuration consists of two sections, a global and a per-port.. The Port Limit Control Configuration screen in
Figure 4-6-4-1 appears.
User's Manual of GS-6320 and MGS-6320 Managed Switches
Information about the last supplicant/client that attempted to authenticate. This
information is available for the following administrative states:
■
Port-based 802.1X
■
Single 802.1X
■
Multi 802.1X
■
MAC-based Auth.
Name IEEE Name
MAC dot1xAuthLastEapolF
Address rameSource
VLAN ID -
Version dot1xAuthLastEapolF
rameVersion
Identity -
372
table). Possible
retransmissions are not
counted.
Description
The MAC address of the last supplicant/client.
The VLAN ID on which the last frame from the
last supplicant/client was received.
802.1X-based:
The protocol version number carried in the most
recently received EAPOL frame.
MAC-based:
Not applicable.
802.1X-based:
The user name (supplicant identity) carried in the
most recently received Response Identity
EAPOL frame.
MAC-based:
Not applicable.