Closing The Burner - Riello RS 45/E LN Installation, Use And Maintenance Instructions

6.4

Closing the burner

To close the burner proceed as follows:
 push the burner 13)(Fig. 36, page 28) at approximately 4"
from the electrical board 14);
 insert the ignition electrode cables and then slide the burner
up to the sleeve so that it is positioned as shown in Fig. 35,
page 28.
 Disinstall and arrange in the correct site the extension bars 4);
 refit screws 2) on slide bars 3);
 secure the burner to the sleeve by tightening screw 1).
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
WARNING
Maintenance
29
GB
20026767