Closing The Burner - Riello RS 68/EV O2 ULX Installation, Use And Maintenance Instructions

4.11

Closing the burner

Once the combustion head adjustment is completed:
 reassemble the burner on the slide bars 3) at about 100 mm
from the pipe coupling 4) burner in the position shown in
Fig. 16 on page 22;
 fit the electrode cable and then slide the burner up to the
pipe coupling, the burner in the position indicated in Fig. 23;
 connect the servomotor connector;
 connect the socket of the maximum gas pressure switch;
 refit the screws 2)on the slide bars 3);
 fix the burner to the pipe coupling with the screw 1)(Fig. 23).
On closing the burner on the two slide bars, it is
advisable to gently pull the high voltage cable
outwards until it is slightly taut.
WARNING
Installation
2
25 GB
4
3
20209347
1
Fig. 23
20205796