Install The Sensor Cartridge - Honeywell Midas S2 User Manual

2.8 Install the sensor cartridge

1. Turn the power off.
2. Verify that the part number and type of sensor cartridge are correct for your application,
then remove the sensor cartridge from the packaging. Remove the Bias battery module and
plug caps from the sensor cartridge if needed.
3. Push the sensor cartridge gently until fully seated.
4. Turn the device ON.
NOTE: There is a connecting and warm-up time which is different according to the sensor
type (Max. 30 mins) for first use. Please wait until the start-up finishes and display the
sensor type on the screen.
5. Confirm the display for gas type and concentration on the screen.
NOTE: All sensor cartridges are supplied calibrated. Some sensor cartridges can monitor
for more than one type of gas. Please refer to Topic 3.6.1: Gas type change and Topic 3.7:
Sensor replacement for details.
Midas S2
FIGURE 2 -9: Installing the sensor cartridge
22 User Manual