Honeywell Midas S2 User Manual page 14

5. Partially screw the fixings into the mounting surface.
6. Place the mounting bracket assembly over the screws, so they pass through the mounting
holes and then slide down to locate in the slots.
7. Tighten the screws to secure the mounting bracket assembly.
8. Align the RJ45 socket of the power PCB module in the hole of the mounting bracket to refit
the PCB.
2
9. Tighten the retaining screw to secure the power PCB module.
10. Wire the device as described in the "Wiring" section.
11. Place the main module back into the base module.
12. Screw the 2 screws located on the main module, as identified in Step 1.
NOTE:Depending on the installation environment of the device, there may be a variation in
pump operation performance due to vibration of a specific frequency or direction, so check
regular pump operation after installation. If you need technical assistance, please contact the
Honeywell Service Team.
Midas S2
1
14 User Manual