Power And Start Up; Battery Power Option; Install/Replace Batteries - Honeywell SmartLine STIW400 User Manual

5. Power and Start up

5.1. Battery Power Option

5.1 Battery Power Option

Install/Replace batteries

WARNING
Risk of death or serious injury from explosion or fire.
•
•
•
•
•
ATTENTION
Both batteries must be the same model from the same manufacturer. Mixing old
and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-
rechargeable), size D. No other batteries are approved for use in SmartLine
Wireless Transmitters.
34 SmartLine Wireless Temperature and Universal I/O User's Manual
5. Power and Start up
When not in use the Battery Pack must be stored in a non Hazardous
Area
Do not change batteries in an explosive gas atmosphere.
The batteries used in this device may present a risk of fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 100°C
(212°F), or incinerate.
When installing batteries, do not snag the battery terminal on the clip or
the battery may be damaged. Do not apply excessive force.
Do not drop. Dropping the battery may cause damage. If a battery is
dropped, do not install the dropped battery into the transmitter. Dispose
of dropped battery promptly per local regulations or per the battery
manufacturer's recommendations.
•
Xeno Energy XL-205F
•
Eagle Picher PT-2300H
•
Tadiran TL-5930/s
•
Tadiran GmbH, SL-2780 (Not approved by FM or CSA)
•
Honeywell p/n 50026010-501 (Two 3.6V lithium thionyl chloride
batteries)
•
Honeywell p/n 50026010-502 (Four 3.6V lithium thionyl chloride
batteries)
•
Honeywell p/n 50026010-503 (Ten 3.6V lithium thionyl chloride
batteries)
Revision 1