North Star M110800J.1 Owner's Manual page 62

Step 17 – Valve Installation
•
Remove plug from cylinder port and discard
•
Lubricate O-ring and threads on fitting with clean oil
•
Orientate (1) Valve Fitting so that nut/washer/O-ring assembly is
facing up. Turn fitting into cylinder port until finger-tight
•
Torque to 27-43 ft.-lb.
•
Looking at fitting from end with nut/washer/O-ring assembly, turn nut
clockwise as far as possible
•
Use valve port marked "A" to thread the control valve onto the fitting
until control valve touches washer
•
Hold control valve in orientation shown below and torque nut to 37-46
ft.-lb.
Fitting Needed from Parts Bag:
O-Ring
Washer
Nut
Part # 790488
Valve Fitting
Qty: 1
Assembly Instructions
Into
Cylinder
Straight Fitting
Cylinder Port
Cylinder
Control Valve
Straight Fitting
62
Hydraulic
Fig05026
Tools Needed
• 7/8" Wrench
(2 needed)
OR
• Crescent Wrench
(2 needed)
• Torque Wrench