North Star M110800J.1 Owner's Manual page 50

Step 8 – Suction Hose from Tank to Pump
• In step 6, a piece of suction hose was installed to the fitting on the
hydraulic tank assembly.
• Locate the other end of the suction hose and the hydraulic pump as
show below.
• Loosen hose clamp as necessary. Slide hose clamp onto end of suction
hose and push onto pump fitting.
• Secure and tighten hose clamp around the suction hose and pump
fitting. Torque to 78 in.-lb.
• Hose clamp must have a tight seal to prevent hydraulic oil from
leaking.
Fasteners Needed from Parts Bag:
Tank to Pump Hose Clamp
Qty 1
110900 and 1131 Only
Assembly Instructions
Tank to Pump Hose Clamp
Qty 1
110800 Only
Suction Hose
Hose
Clamp
Pump Fitting
50
Tools Needed
• Flat Blade Screw
Driver
• Torque Wrench
Hydraulic Pump