Table of Contents
Advertisement
5. Lock jack and
outrigger leg UP
6. Tow to desired
location
7. Lock front
outrigger leg down
and unhitch
Moving and Towing to the Job Site
Move the front outrigger leg to the UP position and lock. (Both outrigger legs
must remain in the up position during towing.)
Attach coupler to class 2
or higher hitch with 2"
ball. Latch securely.
Hook both safety
chains to the towing
vehicle
Tow log splitter carefully to desired work site.
(See Before Each Use section on selecting an appropriate work site)
Important safety instructions:
•
Added length. Be aware of the added length of the splitter.
•
Speed limit. Never tow this log splitter over 45 mph. Faster speeds may
result in loss of control.
•
Rough terrain. Drive slowly and take extra caution when traveling over
rough terrain.
•
On public roads. If towing on a public road, make sure to comply with all
local, state, and federal towing requirements. It is the sole responsibility of
the purchaser to obtain licensing, trailer lights, safety chains or signage, as
needed to comply.
•
Unattended. Turn off the towing vehicle before leaving the splitter
unattended.
•
Under the influence. Never tow or operate this splitter while under the
influence of alcohol, drugs, or medication.
Lock front outrigger leg in the DOWN position and disconnect from vehicle.
NEVER operate log splitter while it is attached to the vehicle.
Lock jack in the
UP position
14
Lock rear outrigger
leg in the
UP position
Advertisement
Table of Contents
