North Star M110800J.1 Owner's Manual page 59

Step 15 – Engine Guard to Beam
NOTE: Engine guard installation varies for all models due to engine size
Assemble to engine guard to the beam in the horizontal position
• Align engine guard bracket to the two sets of holes in the beam
• Slide the vinyl coated clamp located on throttle cable to the hole on the
engine guard shown below. See next page for correct clamp location.
• 110800 Only: Using (4) bolts, (4) nuts and (4) washers, secure engine
guard to beam.
• 110900 & 1131 Only: Using (4) bolts, (4) nuts, and (3) washers, secure
engine guard to beam. Secure vinyl coated loop clamp from previous
step to underside of beam as shown. Do not use washer on bolt used to
secure loop clamp.
• Torque to 20 ft.lb. CAUTION: Over-tightening can crush tube.
Fasteners Needed from Parts Bag:
Engine Guard to Beam
Flange Bolt
Qty 4
Note: Models 110800 &
110900
Engine guard curves
downwards
Assembly Instructions
Engine Guard to Beam
Nyloc Nut
Qty 4
Bolt
Washer
Nut
59
Engine Guard to Beam
Flat Washer
110800 Qty 4, 110900 &
1131 Qty 3
Secure vinyl
coated loop
clamp to this
bolt.
Note: Model 1131 shown
Engine guard curves upwards
Tools Needed
• 13mm Wrench
(2 Needed)
• Torque Wrench
Beam
Engine Guard