Table of Contents
Advertisement
Step 2 – Tire to Tank Assembly
NOTE: Axle nuts are installed (hand tight only) on axles. Remove
from wheel prior to beginning this step. They will be re-installed.
▪ Slide tire onto axle with valve stem facing out.
▪ Slide wheel washer up against the wheel bearing.
▪ Thread axle nut onto axle.
▪ Using a torque wrench, tighten the axle nut to 30-40 ft.- lbs.
Turn hub to ensure proper bearing seating.
▪ Loosen the axle nut until loose enough to turn the axle nut with your
fingers.
▪ Re-tighten the axle nut until finger tight.
▪ Insert cotter pin through hole in axle nut and axle. Bend and spread
prongs in opposite directions so the axle nut will not come off (make
sure the tire spins freely).
Fasteners Needed from Parts Bag (Axle Nuts Located on Tank Assembly):
Cotter Pin
Qty 2
Assembly Instructions
Wheel Washer
Qty 2
Valve Stem
Wheel Bearing
44
Tools Needed
• Pliers
• Torque Wrench
1" Axle Nut
Qty 2
*Partially Installed on Wheel
Not found in Parts Bag
Axle
Tire
Wheel Washer
Cotter Pin
Axle Nut
Advertisement
Table of Contents
