Stihl FSA 200.0 R Instruction Manual page 42

English
8.2 Attaching the barrier bar
► Switch off the brushcutter and remove the bat‐
tery.
► Place the barrier bar (2) on the loop han‐
dle (3).
The barrier bar should close flush with the
loop handle.
► Screw in and securely tighten the screw (1).
8.3 Mounting and Removing the
Deflector
8.3.1 Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Push the deflector (1) into the guides on the
gear housing up to the limit stop.
► Insert the screws (2) and tighten them
securely.
8.3.2 Removing the Deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Unscrew the screws (2).
► Pull off the deflector (1).
42
4 3
2
1
1
1
8.4 Fitting and Removing the Skirt
8.4.1 Attaching the skirt
► Switch off the brushcutter and remove the bat‐
tery.
1
► Slide the guide slot in the skirt (2) onto the uni‐
versal deflector (1) – it must snap audibly into
position.
8.4.2 Removing the Skirt
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin (2) into the hole in the skirt
(1).
► Remove the skirt (1) with the stop pin (2).
The line limiting blade (1) can be left on the skirt.
8.5 Mounting and Removing the
Mowing Head
8.5.1 Mounting the mowing head
► Switch off the brushcutter and remove the bat‐
tery.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
8 Assembling the Trimmer
2
2
1
1
2
3
4
4
0458-041-9601-A
1