Audio Dubbing - JVC GR-DV900 Instructions Manual

EN 59
1) To start playback, press PLAY (1_).
2) Press EFFECT. The PLAYBACK EFFECTSelect
Menu appears.
3) Press EFFECT repeatedty to move the highlight
bar to the desired effect.
• The selected function is activated and after
2 seconds the menu disappears.
• To deactivate the selected effect, press EFFECT
ON/OFF. To reactivate the setected effect press
EFFECT ON/OFF again.
• To change the selected effect, repeat from
step 2 above.
| Audio Dubbing
The audio track can be customised only when
recorded in the 12-bit and SP modes. (_ pg. 34)
Speaker
PAUSE
RM-V717U (provided RM-V718U (provided
with GR-DV900 only) with GR-DVS00/500
only)
1
Play back the tape to locate the point where
editing will start, then press PAUSE (11).
2 White holding A. DUB (_.) on the remote
control, press PAUSE (11).The "11_" and "M[C"
indicators appear.
3 Press PLAY (1_),then begin "narrating". Speak
into the microphone.
• To pause dubbing, press PAUSE (11).
4 To end Audio Dubbing, press PAUSE (11), then
STOP (11).
To hear the sound during Audio Dubbing...
Connect optional headphones to the headphone
connector or use the AV connector, and set the
"12bit MODE" to the desired mode;
• "SOUND 1" for the playback sound.
• "SOUND 2" for the dubbed sound.
• "MIX" for the playback and dubbed sound.
To hear the dubbed sound during playback...
Set "12bit MODE" to "SOUND 2" or "MIX'.
(_;_pg. 31, 40)
NOTES:
• When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
• If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
• If feedback or howling occurs during TVplayback,
move the camcorder's microphone away from the
TV, or turn clown the TV's volume.
• If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
• During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing _
stops.
• ToperformAudioDubbingwhitewatchingonthe
_
television, make connections. (:: pg. 22) I:_
• To perform Audio Dubbing with a video unit
connected to the camcorder's AV connector, first
set "SLAVINPUT" to "ON" in VIDEO Menu.
I_ pg. 31, 40)
The "AUX" indication appears instead of "MIC".