Video Recording & Playback; Videorecording; Basic Recolding; Taperemaining Time - JVC GR-DV900 Instructions Manual

Hide thumbs Also See for GR-DV900:
Table of Contents

Advertisement

VIDEO RECORDING
EN
17
I Basic Recording
NOTE:
Before
continuing,
perform
the procedures
listed
below:
• Powerl;Z'pg.
101
• Loading
A C_ssette
I__" pg. 15)
Power/Charge
Lamp
Power Zoom Lever
Power Switch
Lock Button
Recording Start/Stop
Button
Taffy Lamp
(Lights while recording
is in
progress.)
PUSH OPEN Button
4
Set the Power Switch to "1_1"or "[]" while
pressing down the Lock Button located on the
switch.
• The power/charge
lamp lights and the
camcorder enters the Record-Standby mode.
"PAUSE" is displayed.
5 To start recording, press the Recording Start/Stop
Button. The tally tamp lights and "_
REC"
appears on the display while recording is in
progress.
6 To stop recording, press the Recording Start/Stop
Button again. The camcorder re-enters the
Record-Standby mode.
NOTES:
• The image will not appear simultaneously
on the
LCD monitor and the viewfinde_
• If the Record-Standby mode continues for
5 minutes, the camcorderg power shuts off
automatically.
To turn the camcorder on again,
push back and pull out the viewfinder again or
close and re-open the LCD monito_
• LCD monitor/viewfinder
indications:
• When power is supplied from a battery: the
"_"
battery indicator is displayed. I__ pg. 84)
• When power is supplied from an AC outlet: the
"_"
battery indicator does not appea_
_r
When a blank portion is left between recorded
scenes on the tape, the time code is interrupted
*_
and errors may occur when editing the tape. To
_.
avoid this, refer to "Recording From The Middle
OfA Tape" g_ pg. 19).
• To turn the tally lamp or beep sounds off_
_;:_ pg. 3 I, 37.
• To record in LP (Long Ptayl mode, __ pg. 3 I, 34.
• For other notes, _ pg. 68.
TapeRemaining Time
Approximate
tape remaining time appears on the
display. "-- h - - m" means the camcorder is
calculating the remaining time. When the remaining
time reaches 2 minutes, the indication
starts
blinking.
1
Remove the lens cap.
2
Press PUSH OPEN and open the LCD monitor
fully, or putt out the viewfinder
fully.
Set the VIDEO!MEMORY
Switch to "VIDEO".
-h--m-_l
h Om-_Oh59m-----_Oh
3m
(Now calculating)
Oh Om,<_
Oh 1 m.<_
Oh 2m
(Blinking)
(Blinking)
(Blinking)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gr-dv800Gr-dv500

Table of Contents