Table of Contents
Advertisement
EN37
Wide mode
WIDE MODE
(Factory-preset:
OFF)
OFF: Records with no change
in the screen ratio.
For playback
on a TV with a normal screen ratio.
CINEMA*F'-7: Inser/s black bands at the top and
bottom of the screen. The _
indicator appears,
During playback
on wide-screen
TVs, the black
bands at the top and bottom of the screen are cut
and the screen ratio becomes
16:9. When using
this mode, refer to your wide-screen
TV's
instruction
manual. During playback/recording
on
4:3 TVs/LCD monitor/viewfinder,
black bands are
inserted
at the top and bottom of the screen and
the image appears
like a lelter boxed 16:9 movie.
SQUEEZE*[_]: For playback on TVs with an
aspect ratio of 16:9. Naturally
expands the image
to fit the screen without
distortion.
The []
indicator
appears.
When using this mode, refer to
your wide-screen
TV's instruction
manual.
During
playback/recording
on 4:3 TVs/LCD monitor/
viewfinder,
the image is elongated
vertically.
D.WIDE*ImI:
The []
indicator appears.
The
zoom range is extended
beyond the maximum
optical zoom wide angle range. This mode's wide
angle setting is equivalent
to using a 0.7X wide
conversion
lens, Zooming
is possible from 0.7X to
a magnification
set in CAMERA Menu. This mode
is suitable for shooting
in a small room.
* Available only when the VIDEO/MEMORY
Switch is set to "VIDEO".
Windcut
WIND CUT
(_ctory-preset:
OFF)
OFF: Disengages the function.
ON _.:
Helps cut down on noise created by
wind. The "_."
indica/or appears. The quality of
the sound will change. This is normal.
| System Menu
I_] SYSTEM
Beep, m elody andshutter s ound
BEEP
(Factory-preset: MELODY)
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
REEP:The beep sounds when the power is turned
on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. (_-_pg. 23, 42)
MELODY: Instead of a beep, a melody sounds
when any operation is performed. It also activates
the shutter sound effect. (g::rpg. 23, 42)
Tallylampsetting
TALLY
(Factory-preset: ON)
OFF: The tally lamp remains off at all times.
ON: The/ally
lamp comes on to signal the start of
recording.
Remote control setting
For details, refer to "USING THE REMOTE
CONTROL UNIT" (_ pg. 56).
REMOTE
(Factory-preset:
ON)
OFF: Disables the remote control operations.
ON: Enables the remote control operations.
CONTINUED
ON NEXT PAGE
Advertisement
Table of Contents
