Table of Contents
Advertisement
60
EN
USING THE REMOTE CONTROL UN!T (cont.)
Insert E diting
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
• If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
• During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Edting stops. (:_ pg. 84, 85)
• If a memory card is loaded and "NAVIGATION"
is
set to other than "MANUAL"
a NAVIGATION
thumbnail
image is stored in the memory card.
1:-_pg. 48)
RM-V717U
(provided
with
GR-DVgO0
only)
....
_ . START/STOP
P
REW
AUSE
_--_L
_l_l
PLAY
tNSERT _
CTr_P
j
,J
RM-V718U
(prov,ded w,th GR-
DV800/500
only)
NOTES:
• Before performing the folk_wing steps, make sure
that "TIME CODE" is set to "ON'.
f::mpg. 3 I, 4 I)
• Insert Editing is notpossible
on a tape recorded in
the LP mode or on a blank portion of a tape.
• Toperform Insert Editing while watching in the
television, make connections. (: _ pg. 22)
1 Play back the tape, locate the Edit-Out point and
press PAUSE (11).Confirm the time code at this
point. (_-_" p g. 41)
2 Press REW (_)
until the Edit-in point is located,
then press PAUSE (11).
3 Press and hold INSERT (O) on the remote
control, then press PAUSE (111.The "11(_"
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press START/STOP to begin editing.
• Confirm the insert at the time code you
checked in step 1.
• To pause editing, press START!STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP, then
STOP (11).
NOTES:
• Program AE with special effects _7 pg. 33) can be
used to spice up the scenes being edited during
Insert Editing.
• During Insert Editing, the date and time
information
changes.
I Random Assemble Editing
[R.A.Edit]
Create edited videos easily using your camcorder as
the source player. You can select up to 8 "cuts" for
automatic editing, in any order you like. R.A.Edit is
more easily performed when the MBR (Muhi-Brand
Remote) is set to operate with your brand of VCR
(see "VCR CODE LIST"), but can also be performed
by operating the VCR manually.
Before operation, make sure the batteries are
installed in the remote control. (_-_pg. 56)
For GR-DV800/500
owners:
Use the optional RM-V700U
remote control.
SHIFT
VCR CTL
RM-V717U
(provided
RM-V700U
with GR-DVg00
only)
(optional)
Advertisement
Table of Contents
