Table of Contents
Advertisement
EDITING
50
EN
Audio Dubbing
The audio track can be customized only when
recorded in the 12-BIT and SP modes.
(
pg. 34)
● Use the provided remote control.
Stereo Microphone
Speaker
Headphone connector
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB (D) on the remote
control, press PAUSE (9). The "9D" and "MIC"
indicators appear.
3
Press PLAY (U), then begin "narrating".
Speak into the microphone on the camcorder.
● To pause dubbing, press PAUSE (9).
4
To end audio dubbing, press PAUSE (9),
then STOP (8).
To hear the sound during audio dubbing
Connect optional headphones to the headphone
connector or use the S/AV connector, and set
the "NARRATION" to the desired mode
pg. 33,
;
(
37)
● "OFF" for the playback sound.
● "ON" for the dubbed sound.
● "MIX" for the playback and dubbed sound.
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX".
(
pg. 33, 37)
PAUSE
PLAY
STOP
A
A .DUB
Microphone connector
NOTES:
● When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
● If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for audio
dubbing, it is not effective from the point where
16-BIT recording began.
● During audio dubbing, when the tape moves to
scenes recorded in the LP mode, scenes
recorded in 16-BIT audio or a blank portion, audio
dubbing stops.
● Audio dubbing is also possible using an optional
microphone connected to the microphone
connector.
● While an optional microphone is connected, the
built-in microphone is disabled.
● To perform audio dubbing with a video unit
connected to the camcorder's S/AV connector,
first set "S/AV INPUT" to "A/V IN" or "S IN" in
VIDEO menu. (
pg. 33, 38)
The "AUX" indication appears instead of "MIC".
Advertisement
Table of Contents
