Table of Contents
Advertisement
Page 42 - Initial Assembly
Dual Modem Module
An optional Dual Modem Module (see pages 10, 14 and 18) is fitted to an IP Office base
unit as follows:
Procedure
1. Remove the three fixing screws on the rear of cover.
2. Turn the unit over and remove the four fixing screws from the base.
3. Slide the cover from the unit.
4. Mount the module in position as shown below and secure with the two snap-in spacers.
5. Replace the cover and secure with the seven fixing screws.
CAUTION: While installing, ensure that you wear a ground wrist strap that is connected
Page 42 - Installing a New System
Initial Assembly
to a suitable grounding point.
Installing a New System
IP Office Installation Manual
40DHB0002UKCL – Issue 9 (28 October 2003)
Advertisement
Table of Contents
