Table of Contents
Advertisement
Installing a New System
Installation of Voice Compression Modules (VCM)
Optional Voice Compression Modules (only one for IP 403/IP406 module and a max. of
two for IP412, see pages 10, 14 and 18 respectively) are fitted to an IP Office base unit as
follows:
Procedure
1. Remove the three fixing screws on the rear of cover.
2. Turn the unit over and remove the four fixing screws from the base.
3. Slide the cover from the unit.
4. Mount the VCM in position as shown below and secure with the two snap-in spacers.
Only an IP412 Office can accommodate a second VCM (of any type); the first module
can be mounted in either position.
5. Replace cover and secure with the seven fixing screws.
CAUTION: While installing, ensure that you wear a ground wrist strap that is connected
IP Office Installation Manual
40DHB0002UKCL – Issue 9 (28 October 2003)
to a suitable grounding point.
Initial Assembly - Page 41
Installing a New System - Page 41
Initial Assembly
Advertisement
Table of Contents
