Continuous Play - Aiwa Z-R900 Operating Instructions Manual

MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
When the ® indicator of the <> button is flashing, press
the BP button to move to the next track or the << button to
move to the beginning of the current track.
When the ~<@ indicator of the <® button is flashing, press
the <4 button to move to the next track, or the BP button to
move to the beginning of the current track.
The search function may not be able to detect tracks under the
following conditions:
¢ Blanks of less than 4 seconds between tracks
* Noisy blanks .
« Long passages of low-end sound
* Low overall recording levels
CONTINUOUS PLAY
gp= © N
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into Deck 1 and Deck 2.
2 Press the TAPE/DECK 1/2 button to select the
deck to be played back first.
3 Press the REV MODE button to select =).
4 Press the <b button to start playback.
Playback continues until the I button is pressed.
13 ENGLISH
ty
About cassette tapes
¢ To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other. pointed tool. ;
Side A
Type II tape Tab for side A
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
* 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
¢ Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
ey