13
WIRING HARNESS, BATTERY
13.6
Checking the charging voltage
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the passenger seat. (
–
Remove the seat. (
–
Disconnect the negative cable of the battery to avoid damage to the motorcycle's
electronics.
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid
Charge the battery with a maximum of 10% of the capacity specified on
battery housing
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
B01395-10
Finishing work
–
Mount the seat. (
–
Mount the passenger seat. (
–
Set the clock. (
Condition
The battery must be fully functional and completely charged.
Preparatory work
–
Remove the passenger seat. (
–
Remove the seat. (
Main work
–
Start the motorcycle to make checks. (
–
Measure the voltage between the specified points.
Measuring point Plus (+) – Measuring point Ground (−)
Charging voltage
5,000 rpm
»
If the displayed value is less than the specified value:
–
Check the cable from the alternator to the voltage regulator.
–
Check the cable from the voltage regulator to the wiring harness.
–
Check the stator winding of the alternator. (
304934-10
»
If the displayed value is greater than the specified value:
–
Change the voltage regulator.
p. 46)
p. 45)
.
1
.
2
3 months
p. 46)
p. 46)
p. 95)
p. 46)
p. 45)
p. 14)
13.5... 15.0 V
76
p. 220)