3-2. Setting Input Signal
Signals can be selected based on your operating environment.
Attention
• A supported graphics board is required to display.
• Refer to the User's Manual of the graphics board.
●
To connect DVI
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Signal Selection" from "Optional Settings", and press
4. Select "DVI" with
5. Select "Signal Format" with
6. Select "Standard" or "SDG 8" with
7. Select "Sub Pixel Drive" with
8. Leave the default setting "Off" as it is, and press
9. Press
10. Select "Finish" with
11. Press
.
The "Optional Settings" menu is closed.
Attention
• If "Sub Pixel Drive" is set to "On", the screen is not displayed properly.
●
To connect DisplayPort
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Signal Selection" from "Optional Settings", and press
4. Select "DisplayPort" with
5. Select "Sub Pixel Drive" with
6. Leave the default setting "Off" as it is, and press
7. Press
8. Select "Finish" with
9. Press
.
The "Optional Settings" menu is closed.
Attention
• If "Sub Pixel Drive" is set to "On", the screen is not displayed properly.
down, press
for at least two seconds to turn on the monitor.
or , and press
or , and press
or , and press
or , and press
twice.
or .
down, press
for at least two seconds to turn on the monitor.
or , and press
or , and press
twice.
or .
.
.
.
.
.
.
.
.
.
.
Chapter3SettingMonitor
13