Table of Contents
Advertisement
Codabar (NW - 7)
Enable/Disable Codabar
To enable or disable Codabar, scan the appropriate bar code below.
Set Lengths for Codabar
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Codabar to any length, one or two discrete lengths, or lengths within a specific
range.
One Discrete Length - Select this option to decode only Codabar symbols containing a selected length. Select the
length using the numeric bar codes in
symbols with 14 characters, scan Codabar - One Discrete Length, then scan 1 followed by 4. In case of an error,
or to change the selection, scan Cancel on
Two Discrete Lengths - Select this option to decode only Codabar symbols containing either of two selected
lengths. Select lengths using the numeric bar codes in
only those Codabar symbols containing either 2 or 14 characters, select Codabar - Two Discrete Lengths, then
scan 0, 2, 1, and then 4. In case of an error, or to change the selection, scan Cancel on
Enable Codabar
*
Disable Codabar
Appendix D, Numeric Bar
page
D-3.
Codabar - One Discrete Length
Appendix D, Numeric Bar
Codabar - Two Discrete Lengths
Codes. For example, to decode only Codabar
Codes. For example, to decode
Symbologies 12 - 37
page
D-3.
Advertisement
Table of Contents
