Table of Contents
Advertisement
4 - 6
Symbol LS3408 Product Reference Guide
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan attempt. Select a 0.1
second increments from 0.5 to 9.9 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes in
Codes
that correspond to the desired on time. Enter a leading zero for single digit numbers. For example, to set a
Laser On Time of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. In case of an error, or to
change the selection, scan Cancel on
Beep After Good Decode
Scan a bar code below to select whether or not the scanner beeps after a good decode. If you select Do Not Beep
After Good Decode, the beeper still operates during parameter menu scanning and indicates error conditions.
page
D-3.
Laser On Time
*
Beep After Good Decode
(Enable)
Do Not Beep After Good Decode
(Disable)
Appendix D, Numeric Bar
Advertisement
Table of Contents
