Table of Contents
Advertisement
Trigger Mode
Set the trigger mode using the bar codes below.
Level Trigger
Upon a trigger pull, an aiming dot appears for a programmable duration of time. After this time, the aiming dot turns
into a standard laser scanning beam for a full decode session. The laser scanning beam stays on until the laser-on
timeout occurs, a decode occurs, or you release the trigger. If you release the trigger before the aiming duration
expires, the laser shuts off and no decode occurs.
Two Stage - Option 1
Upon a trigger pull, an aiming dot appears. This aiming dot remains while the trigger is pulled. Releasing the trigger
turns the aiming dot into a standard laser scanning beam for a full decode session. The laser scanning beam stays
on until the laser-on timeout occurs or a decode occurs. If you pull the trigger again while in a decode session, the
scanner beam returns to an aiming dot.
Two Stage - Option 2
Upon a trigger pull, an aiming dot appears. Releasing the trigger turns off the aiming dot. Pulling the trigger twice in
rapid succession turns on the standard laser scanning beam for a full decode session. The laser scanning beam
stays on until the laser-on timeout occurs, a decode occurs, or you release the trigger.
*Level
Two Stage - Option 1
Two Stage - Option 2
User Preferences
4 - 7
Advertisement
Table of Contents
