Table of Contents
Advertisement
Setting the transmitter to pairing mode
1
ON
LED
3
1. Make sure that the transmitter is properly connected to the TV or
audio source (> 8) and switch it on (> 12).
2. Press the pairing button on the rear of the transmitter while the
earbuds are still in pairing mode (in pairing mode, the 3 light indi-
cators of the charging case flash blue).
The front LED of the transmitter flashes blue briefly.
When the 3 blue light indicators of the charging case stop flash-
ing, the pairing process is successfully completed (usually < 5
seconds).
Your transmitter is now connected to the earbuds and the light
indicators on the charging case stop flashing.
If, after 5 seconds, the 3 blue light indicators of the charging
case do not stop flashing, press the transmitter's pairing
button again.
3. Insert the earbuds into your ears. The sound from your transmit-
ter will be played through the earbuds when they are connected.
Additional information on pairing
• The success of the pairing process is independent of whether or
not there is an audio input.
• You can pair the transmitter with any number of compatible prod-
ucts. The transmitter streams the audio signal to all paired
devices simultaneously.
• A device only needs to be paired with the transmitter once, unless
the pairing is deleted on the side of the headphones.
2
LED
Sennheiser TV Clear Transmitter 2 | 11
Getting started
Advertisement
Table of Contents
