Securing The Lines - Siemens SIMATIC IPC PX-32A Operating Instructions Manual

Installing and connecting the device
3.3 Connecting the device
3.3.5

Securing the lines

The strain relief (see "scope of delivery (Page 25)") provided is used to prevent accidental
loosening of the interface cables from the device.
Requirements
• I/O devices are connected to the respective interfaces.
• 1 screwdriver of type Torx T10
• 1 cable grip (not included in the scope of delivery)
• Cable ties (not included in the scope of delivery)
• 2 screws (not included in the scope of delivery)
Procedure
1. Fasten the strain relief at the
marked points using the
supplied pan-head screws.
2. Pass the cable tie around the strain relief
bar and secure the cables as shown.
3. Cut off the protruding ends of the cable
ties.
42
Operating Instructions, 09/2023, A5E53092695-AA
SIMATIC IPC PX-32A