Configuring Lan Information For The Mp; Figure 4-13 The Lc Command Screen - HP Integrity rx8620 User's & Service Manual

Cabling and Power Up

Configuring LAN Information for the MP

Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port information.
LAN information includes the MP network name, the MP IP address, the subnet mask, and gateway address.
This information is provided by the customer.
To set the MP LAN IP address:
1. At the MP Main Menu prompt (MP>), enter cm. From the MP Command Menu prompt (MP:CM>), enter
lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea to write
down the information or log it to a file, as it may be required for future troubleshooting.
NOTE If the Command Menu is not shown, enter q to return to the MP Main Menu, then enter cm.
Enter lc and press the
Figure 4-13 The lc Command Screen
The value in the "IP address" field has been set at the factory. Obtain the LAN IP address
NOTE
from the customer.
2. At the prompt, Do you want to modify the configuration for the customer LAN? , enter y.
The current IP address is shown; then the following prompt is displayed: Do you want to modify it?
(Y/[N] )
90
key. The following screen is displayed:
Return
Chapter 4