Top And Side Cover Installation; Figure 2-14. Cover Locations - HP Integrity rx8620 User's & Service Manual

Installation
Wheel Kit Installation

Top and Side Cover Installation

It may be necessary to remove existing top and side covers installed on the server before
NOTE
installing the covers shipped with the wheel kit. If cover removal is not needed, go directly to
the sections for installing the top and side cover.
Figure 2-14 Cover Locations
Top Cover
Side Cover
Front Bezel
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Removing the Top Cover
Step 1. Connect to ground with a wrist strap.
Step 2. Loosen the blue retaining screws securing the cover to the chassis.
Step 3. Slide the cover toward the rear of the chassis.
Step 4. Lift the cover up and away from the chassis.
54
Chapter 2