Configuring Lan Information For The Mp; Mp Main Menu - HP rp7420 Service Manual

• When power is first applied. The BPS LEDs flash amber.
• After 30 seconds has elapsed. The flashing amber BPS LED for each BPS becomes a
flashing green LED.
To interpret LED indicators, see the power cord policies.
3. Log in to the MP:
a. Enter Admin at the login prompt. The login is case sensitive.
It takes a few moments for the MP prompt to display. If it does not display, verify the
laptop serial device settings are correct:
8 bits, no parity, 9600 baud, and na for both Receive and Transmit. Then, try again.
b. Enter Admin at the password prompt. The password is case sensitive.
The MP Main Menu is displayed:
Figure 4-7 MP Main Menu

Configuring LAN Information For the MP

To set the MP LAN IP address, follow these steps:
1. At the MP Main Menu prompt (MP>), enter cm.
2. From the MP Command Menu prompt (MP:CM>), enter lc (for LAN configuration).
The default values display, and a prompt to modify the default values displays.
Write down the information for future use.
NOTE:
enter cm.
3. Enter lc and press the Return key.
The following screen displays:
58 Cabling and Powering the Server
If the Command Menu is not shown, enter q to return to the MP Main Menu, and