Troubleshooting
HP Integrity rx8620 Server LED Indicators
Core I/O Buttons
There are two recessed buttons on the back of the core I/O card, as explained in Table 5-8.
Figure 5-8
Core I/O Button Location
MP Reset
Table 5-8
Core I/O Buttons
Button
Identification
(as silk-screened
on the
bulkhead)
MP RESET
OLR (Symbol next
to button is shown
below)
116
Location
To the far left side of
the core I/O card
To the far right side of
the core I/O card
Function
Resets the MP
NOTE: If the MP RESET button is held for longer
than five seconds, it will clear the MP password
and reset the LAN, RS-232 (serial port), and
modem port parameters to their default values.
LAN Default Parameters
•
IP Address - 192.168.1.1
•
Subnet mask - 255.255.255.0
•
Default gateway - 192.168.1.1
•
Hostname - gsp0
RS-232 (Serial Port) Default Parameters
•
9600 baud
•
8 bits
•
No parity
Remote/Modem Port Parameters
•
Disabled
Request OL* for this core I/O slot
NOTE: The OLR function is not enabled for the
core I/O card.
OLR
Chapter 5