Removal and Replacement
Removing and Replacing Covers
Removing and Replacing Covers
It is necessary to remove one or more of the covers to access many of the CRUs within the HP Integrity
rx8620 Server chassis.
CAUTION
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Figure 6-1
Cover Locations
Top Cover
Side Cover
Front Bezel
Removing the Top Cover
Step 1. Connect to ground with a wrist strap. Refer to "Electrostatic Discharge" on page 138 for more
information.
Step 2. Loosen the blue retaining screws securing the cover to the chassis.
Step 3. Slide the cover toward the rear of the chassis.
Step 4. Lift the cover up and away from the chassis.
142
Chapter 6